Security Camera Installation Steps for Analog System
Mounting the camera
Place the camera unit at the desired place, make guide marks for drilling. Drill holes and hammer in the screw mouldings. Now, screw the camera in place firmly. Insert the power cable of the camera in a socket
DVR of the CCTV is the place where the surveillance hard disk is present. Thus all your CCTV recording reside inside a DVR. It is highly recommended to keep the DVR inside a locked compartment so that even if an intruder spots the DVR, he/she can’t destroy the recorded videos. This is a vital step to ensure a bullet proof security system for your home.
Managing the cables
Plan the pathway for all the cables from cameras to DVR unit. Use wire moldings to keep the wire managed and safe. Nail the moldings along the path and put the Siamese surveillance wire inside.
Connecting the wires
The video cable is connected via a BNC port. Remove about 1.5cm of outer covering of the video cable which should now expose the braids. Slide the crimping barrel onto the cable with wider diameter facing towards the end of the cable. Now remove the white insulator covering the innermost cable. Now insert this exposed cables into the BNC port and screw the crimping barrel. This makes a secure connection. Connect the DVR output port to the screen on which you want the video feed.
Start by powering ON the cameras followed by the display and the DVR. Setup the DVR according to the user manual provided with the DVR. Go over every camera’s feed to confirm each camera is working properly and providing the desired viewing angle.